[gufiak]

jackk11111, ok, but on these pins there is also +/-12V. But first try to revive your player like dinderi says (using the correct cable - with the level translator). Maybe the processor is not dead.

[jackk11111]

hello, I bought the parts but the colors of resistance are different than those in the picture, why?
example: 22k = red red orange yellow

[gufiak]

Resistors in this picture are 5-bands resistors. You have probably more popular 4-band resistors. You can check your resistors using this color table:

[jackk11111]

I can use 4-band resistors anyway?

[gufiak]

Yes, you can use any type of resistors. Only the value is important.

[jackk11111]

Hello, I used cable ericcson t28 because i have problems with resistors,I also used V3+ connector. unknown flash memory, but flash ok 100%! But when I turn the player, the same problem, dead player but hdmi led turn! what should I do?

[dinderi]

You may try to unplug power cord after upgrade, plug again and turn the player on. Remember, it needs bit more time to start now, then everage.

[jackk11111]

doesn't work. player dead and hdmi led red!

[dinderi]

try again using MTKCom 0.2.5

[gufiak]

jackk11111, so probably it's completely dead.

[jackk11111]

how to configure memory address and count?

[gufiak]

Just leave this unchanged. This is for more advanced operations. To flash a firmware you just have to load a firmware and click "Upgrade". That's all.

[jackk11111]

always and only red led hdmi, dead dead and dead

[dinderi]

This unit seems to need new mother board

[!NoWorries]

Have you tried to use the MTKTool 2.42.12?
The problem is that the indication bar can be running even if the connection to the PCB card is not 100%, specially with MTKTool 1.31.